| When an installation includes
a raised bond beam, wall, rock or waterfall, the regular anchoring
procedure cannot be used because of inadequate deck area.
In these situations, the cover will be manufactured with snap
hooks sewn to the underside. The snap hooks are designed to
fasten to eyebolts (also provided with the cover) which must
be installaed in the raised wall.
IMPORTANT:
Install this section of the cover FIRST. Never attempt to
bypass use of snap hook when cover is provided with them.
All covers MUST be installed drum-tight to eliminate
excessive wear, which will NOT be covered under our 12 year
pro-rated warranty. Following the below procedure
is cruical to ensuring proper installation and wear of the
cover. |
| Step 1:
Using the Anchor Plan provided with the cover, locate eyebolt
locations.
Step 2:
At first eyebolt location, drill a 3/8" hole to a depth
of 3".
Step 3:
With the washer on the eyebolt, thread the eyebolt 4 complete
turns (approximately half way) into the wall anchor.
Step 4:
Insert the wall anchor assembly into the 3/8" hole until
the washer is pressed against the wall (you may have to tap
with a mallet).
Step 5:
Using a screwdriver, turn the eyebolt in a clockwise direction
to "set" the wall anchor. Remember to end with the
eyebolt in the horizontal position.
Step 6: (Tile Application)
For tile applications, two bits will be needed.
1/2" Glass Bit
3/8" Standard Bit noted in Step #2
Drill through tile using 1/2" glass bit. Once the bit
breaks through the tile, switch to the 3/8" bit noticed
in Step #2. Complete with Step's 3-5
SPECIAL NOTE: The hole must
be drilled the entire 3", to prevent the eyebolt aseembly
from sticking too far out and away from the pool. |
