 |
Safety
Cover Installation Guide
Installing your own
safety cover can save you a lot of money and
with our installation guide, it couldn't be
easier! With our detailed diagrams and step-by-step
instructions you should have your safety cover
installed quickly and safely.
If you need help installing your safety cover,
give us a call and we will help you along!
|
|
|
| Click
on the titles below to view guide |
|
|
|
|
|
 |
Figure
13 |
| When
an installation includes a raised bond beam, wall,
rock or waterfall, the regular anchoring procedure
cannot be used because of inadequate deck area. In
these situations, the cover will be manufactured with
snap hooks sewn to the underside. The snap hooks are
designed to fasten to eyebolts (also provided with
the cover) which must be installaed in the raised
wall.
IMPORTANT:
Install this section of the cover FIRST. Never attempt
to bypass use of snap hook when cover is provided
with them. All covers MUST be installed drum-tight
to eliminate excessive wear, which will NOT be covered
under our 12 year pro-rated warranty. Following
the below procedure is cruical to ensuring proper
installation and wear of the cover. |
|
| |
|
Step
1:
Using the Anchor Plan provided with the cover, locate
eyebolt locations.
Step 2:
At first eyebolt location, drill a 3/8" hole
to a depth of 3".
Step 3:
With the washer on the eyebolt, thread the eyebolt
4 complete turns (approximately half way) into the
wall anchor.
Step 4:
Insert the wall anchor assembly into the 3/8"
hole until the washer is pressed against the wall
(you may have to tap with a mallet).
Step 5:
Using a screwdriver, turn the eyebolt in a clockwise
direction to "set" the wall anchor. Remember
to end with the eyebolt in the horizontal position.
Step 6: (Tile Application)
For tile applications, two bits will be needed.
1/2" Glass Bit
3/8" Standard Bit noted in Step #2
Drill through tile using 1/2" glass bit. Once
the bit breaks through the tile, switch to the 3/8"
bit noticed in Step #2. Complete with Step's 3-5
SPECIAL
NOTE: The hole must be drilled the entire
3", to prevent the eyebolt aseembly from sticking
too far out and away from the pool.
|
|
$9.95
SHIPPING ON ALL ORDERS $199.99 & LOWER. $19.95 SHIPPING ON ALL ORDERS $200.00 OR MORE!*
No Additional
Handling Charges** |
*
Additional shipping costs apply for certain zip codes.
Please call for information and pricing.
** Not applicable for some zip codes. We will contact you if your zip code
is affected. Additional charges apply for HI and AK Orders, as well as orders
from outside the Continental US. Please call for pricing.
|
|
